Filter
Top Products
34
SELECTING A SPECIAL MODE
The procedure for selecting settings for "Adding margins (Margin Shift)" is explained below as an example.
Although the specific settings for each special mode vary, the general procedure is the same.
1 Place the originals.
When using the document glass, place the
original with the side to be scanned face down.
2 Select settings in the touch panel.
(1) Touch the [Special Modes] key.
(2) Touch the [Margin Shift] key.
Shifting the left margin by 15 mm will be
explained as an example.
(3) Select 15 mm for the front side and
15 mm for the reverse side using
the keys.
The margin shift position is initially set to
"Right".
To change the position to "Left" or "Down",
touch the corresponding key.
(4) Touch the [OK] key.
3 Set the number of copies and then
press the [START] key.
The side to be scanned must be face up!
Ready to scan for copy.
2-Sided Copy
0
Output
Special Modes
File
Quick File
Auto
Exposure
100%
Copy Ratio
Job Detail
Settings
Special Modes
OK
1/4
Margin Shift
Pamphlet Copy
Erase
Tandem
Copy
Dual Page
Copy
Job
Build
Special Modes
OK
OKCancel
Margin Shift
Right Left Down
Side 1 Side 2
15 15
(0~20)
mm
(0~20)
mm
Original
Plain
2.
3.
4.
1.
A3
A4
B4
A4R
A4
A4
(1)
(2)
(3)
(4)
Cancel copying
Cancel scanning
Correct sets