Filter
Top Products
77
CHANGING THE FILE FORMAT
The file format (file type and compression method) for sending a scanned image is specified when the destination
is stored in a one-touch key; however, you can change the format at the time of transmission.
The procedure for sending a scanned image in TIFF format is explained below.
1 Place the originals.
When using the document glass, place the
original with the side to be scanned face down.
2 Select format settings in the touch
panel.
(1) Touch the [Image Settings] key.
(2) Touch the [File Format] key.
(3) Read the displayed message and
touch the [OK] key.
(4) Touch the [TIFF] key.
(5) Touch the [MMR(G4)] key.
This sets the compression to high.
A higher compression ratio creates a
smaller file size.
(6) Touch the [OK] key.
3 Select the destination and press the
[START] key.
If the file type is set to [Encrypt PDF], you will be
prompted to enter a password when you start
transmission.
The side to be scanned must be face up!
XPS
None
MH (G3)
MMR (G4)
File Type Compression Mode
OK
TIFF
PDF
Encrypt PDF
Programmed
Specified Pages per File
(1-99)
Quick File
File
Special Modes
Address Entry
Address Book
Scan
Mode Switch
Image
Settings
Send Settings
Auto
Exposure
200X200dpi
PDF
Resolution
File Format
Original
Special Modes
Select a file format to apply it to
all scan destinations.
OK
Auto
A4
(2)
(3)
(6)
(5)
(1)
(4)
Cancel scanning