Filter
Top Products
US-13
It is possible, and in some locations highly likely, that your radio will find more than one wireless
access point, in which case you can choose which one you want to connect to. Turn the knob on
the radio to see the ESSID of each access point the radio has found.
Step 3 Connect to the wireless network
When the ESSID for the access point you want is displayed on the screen, press the SELECT
button. If your network is not configured to need an encryption code, the screen should say:
Then:
If the screen displays either:
Or:
Then the network is using one of the encryption systems: Wired Equivalent Privacy (WEP) or Wi-
Fi Protected Access (WPA). You therefore need to enter the correct WEP or WPA code or “Key”
into the radio to get it to communicate with your network.
Only the person who set up the network in the first place knows this code; if that person is not
you then you need to find out what it is.
After 3 seconds, the display goes into the code entry mode. To enter the code, use the knob to
select each character of the code in turn, pressing the SELECT button after each character.
Note that WEP and WPA codes are sensitive to upper and lower case characters so you must
enter them exactly.
Use the BACK button to erase incorrect characters.
After the final character, use the knob to select the <END> character and press the SELECT
button.
The radio should now be able to connect to the network. If the display shows “Invalid key” or
“Network Error”, an incorrect password has probably been entered.
Connecting to network
Network OK
Enter WEP key
Enter WPA key