Filter
Top Products
PUTTING THE BATTERIES INTO THE REMOTE CONTROL UNIT
Press down the compartment cover, and slide the
cover off to open the compartment. Place the two
(UM4), (AAA), (R03) batteries in the remote control
according to the polarity markings ("+" and "-”) inside
the compartment and on the batteries.
Place the cover over the compartment, press down
lightly, and push it upward until it snaps on.
BATTERY PRECAUTIONS
Follow these precautions when using a battery in this device:
1. Warning -Danger of explosion if battery is incorrectly
replaced. Replace only with the same or equivalent type.
2. Use only the size and type of battery specified.
3. Be sure to follow the correct polarity when installing the battery
as indicated in the battery compartment.
A reversed battery may cause damage to the device.
4. If the device is not to be used for a long period of time, remove
the battery to prevent damage or injury from possible battery
leakage.
5. Do not try to recharge a battery not intended to be recharged;
it can overheat and rupture. (Follow battery manufacturer's directions.)
6. Battery shall not be exposed to excessive heat such as sunshine, fire or the like.
**BATTERIES NOT INCLUDED**
INSTALLING THE SPEAKER WIRE TO THE SPEAKER TERMINALS
OPERATING THE UNIT
Before operating the unit for the first time, make sure the AC power cord is properly connected to a 240V 50Hz
AC outlet, then press the power ON switch on the rear of the unit, the unit will be in standby mode, The STANDBY
indicator will light on. You can now press the STANDBY/ON button on the unit or press the STANDBY/ON button
on remote control to switch the unit ON. The STANDBY indicator will be off. Pull the AC plug out of the wall socket
if you want to switch off completely.
STANDBY/ON
1. Press the STANDBY/ON button on the unit or remote control to switch the unit on.
2.
3. Adjust the volume with the (+ or -) knob on the unit or VOLUME (+ or -) button on the remote control.
4. Press the STANDBY/ON button on the unit or remote control again to turn off the unit.
Note: 1. During in standby mode, press any button/key can make the display light for 10 seconds.
2. Please turn the main switch off to save energy, when you do not use the unit.
Select the sound source (CD, USB, CARD, iPod, AUX or TUNER) by pressing FUNCTION button. The
corresponding display will light up.
VOLUME
1. Speakers Connection
Extend the SPEAKER WIRES and connect them
to the SPEAKER TERMINALS.
2. Power Cord Connection
Before using, connect the AC Power Cord to
240V AC outlet. Then turn on the main switch
on the rear of the unit. The STANDBY indicator
will light on.
AC CORD
AC MAIN POWER SWITCH
5