Sanyo DC-MX40i MP3 Docking Station User Manual


 
Sound is heard from one speaker.
Faulty connection of speaker wires.
Connect the speaker wires firmly to the
speaker terminals.
The CD player does not start playback. No disc is
loaded.
Loaded a disc.
An unplayable disc is loaded. Load a playable disc.
The disc is not loaded correctly.
Load the disc with the label facing up on the disc tray.
The disc is dirty.
Clean the disc or replace it.
The CD player does not start playback and
“NO FILE” appears.
An unplayable disc is loaded. Load a playable disc.
The disc is not loaded correctly.
Load the disc with the label facing up on the disc tray.
The operation of the unit or display is not normal.
The unit must be reset.
1. Disconnect the main lead and replug again.
2. Resume operations.
The file in USB or SD card cannot play back. USB
device is not connected.
Connect the USB device. SD card is not loaded.
Load the SD card.
The file is copyright protection file. Select the
correct playable files.
FM stereo broadcast is hard to hear due to much
noise.
Weak signal.
Press the ID3/MONO/ST. button on the remote control
to display “MONO”.
Reorient the FM aerial wire. Connect the speaker
wires firmly to the speaker terminals.
The remote controller does not work properly. The
batteries in the remote controller are weak, or
installed incorrectly.
Check the battery polarity (+ or -). Replace the battery.
The remote controller is not aimed at the remote
sensor window.
Aim the remote controller at the remote sensor window.
15
TROUBLE SHOOTING
SYMPTOM
POSSIBLE CAUSE CORRECTIVE ACTION
No power
No mains lead plug connection at the AC outlet.
Insert the plug into the AC outlet.
The power is on, but the CD player does not work.
No disc is loaded.
Load a disc.
No sound.
Volume control is set to minium.
Turn up the volume.
The wrong function is selected.
Select the correct function.
Faulty speaker connections.
Connect the speaker wires firmly to the
speaker terminals.