Filter
Top Products
60
Recording
• A band’s performance is louder than everyday
sounds. Set the [MIC GAIN] switch to L.
• When you set the recording level, make
adjustments during the loudest section of the
song. You can use the rehearsal function to
automatically set the appropriate recording level.
• In a practice room, the instruments are typically
placed around the edge of the room facing into
the center. In order to record all instruments at a
good balance, place the mic in the center of the
room, at approximately table-top height to get
the best sound. Placing the mic on the floor will
produce a muffled sound with excessive low
frequencies; placing the mic at a high location will
fail to capture the lows, producing a thin sound.
• If you turn the Auto Rec Start function on, you
won’t have to press [ ]; recording will start
automatically when the band begins playing.
Choose a setting of Level 1–Level 3.
• If you set Rec Mode to WAV+MP3, a high-quality
archival master and a compact file for
distribution will be recorded simultaneously.
Recommended settings
Recording a Band
Rear panel switches
MIC GAIN L
LIMITER OFF
LOW CUT OFF
“Menu” screen settings
Recorder
Setup
Sampling Rate
44.1 kHz if you’re creating a CD
Rec Mode WAV-16 bit or WAV+MP3
Auto Rec Start Level1–Level3
Input
Setup
Rehearsal
Time
30sec–5min
R-05-e.book 60 ページ ２０１０年２月１９日 金曜日 午後４時５５分