Filter
Top Products
49
Recording
Setting the function of the [LIMITER] switch
1. Press [MENU] to access the “Menu” screen,
use [ ]/[ ] to select “Input Setup,” and
press [ ].
fig.recoedersetting.eps_80
2. Use [ ]/[ ] to move the cursor to the
Limiter/AGC setting, and use [ ]/[ ] to
select either Limiter or AGC.
fig.recoedersetting.eps_80
3.
Press [MENU] twice to return to the main screen.
If AGC is on, INPUT [+] [–] is disabled, and you won’t
be able to adjust the recording level manually.
By turning on the [LOW CUT] switch on the rear
panel, you can cut the low range below a specified
frequency.
fig
Normally, you can leave this off.
If you have problems with low-frequency noise, such
as the wind noise that is often present in outdoor
recordings, the rumble from automobiles or
machines, or vibration, you may be able to reduce
this noise by cutting the low-frequency range.
If you have problems with the breath noise or
muffled tone that can occur when recording a vocal,
cutting the low-frequency range will give you a more
crisp recording.
Cutting the Low-Frequency Range
R-05-e.book 49 ページ ２０１０年２月１９日 金曜日 午後４時５５分