Filter
Top Products
5
Operating your clock radio
1. Press the On / Standby button to switch on your clock radio. The
display will show "TUNING" for a few seconds.
When first switched on, the radio will be in DAB mode. After each use
the radio will remember the mode used and then switch on in that
mode the next time that it is used.
2. If the clock radio has been used before, the last used station will be
selected.
3. If this is the first time that the radio has been used, then the first station
in the list of stations found during scanning will be played. The display
will show the station name on the display.
4. If no signals are found then "OFF AIR" will be displayed and it may
be necessary to relocate your clock radio to a position giving better
reception. You should then carry out a scan to find stations as described
on page 9.
• Your clock radio has a indicator
on the display to indicate the
strength of the signal being received.
• The display will revert to a conventional time display 10 seconds after
the last button press except when displaying scrolling text.
Note: If you can see the name of the radio station on the display, but
cannot hear any sound, you may need to adjust the volume control which
is located on the right hand side of your clock radio.
1