Filter
Top Products
4
Using the clock radio for the first time
1. Place your clock radio on a flat surface.
2. Fully extend the wire aerial located on the rear of your clock radio.
Place the wire antenna so that it is as straight as possible extending
either above or below the radio.
3. Insert the adaptor plug into the DC socket located on the rear of your
clock radio. Plug the adaptor into a standard 13 amp mains socket
outlet. The display will show "ROBERTS" for a few seconds and then
the display will then show "SET CLOCK". During this time the radio
is scanning to find out which DAB radio stations are available. After a
short time the current time will appear on the display.
4. If no stations are found, "NO CLOCK" will be displayed. It may be
necessary to relocate your clock radio to a position giving better
reception. You should then carry out a scan to find stations as described
on page 9.
IMPORTANT: The mains adaptor is used as the means of connecting
the clock radio to the mains supply. The mains socket used for the clock
radio must remain accessible during normal use. In order to disconnect
the clock radio from the mains completely, the adaptor should be removed
from the mains socket outlet completely.
Characters appearing on the LCD display indicate that the radio is connected
to and powered from the mains supply.
DC 6v
800mA