Filter
Top Products
13
Manual tune - FM
1. Fully extend the wire aerial located on the rear of your clock radio.
Place the wire antenna so that it is as straight as possible extending
either above or below the radio.
2. Press the
On / Standby button to switch on your clock radio.
3. Press the
Band button to select the FM band.
4. Press the Tuning Up or Down buttons to tune to a station. The
frequency will change in steps of 50kHz. Pressing and holding the
buttons will advance the frequency several times each second.
If the radio is tuned to a station of sufficient signal strength with RDS
information present, then the display may change to show the station
name.
5. When the end of the waveband is reached the radio will recommence
tuning from the opposite end of the waveband.
6. Set the Volume to the desired setting.
7. To switch off your clock radio press the Standby button.
Note: The display will revert to a conventional time display 10 seconds
after the last button press except when displaying scrolling text.
2,7
3
TUNING
SNOOZE
down
up
4 4
VOLUME
6