Surround sound setup
09
57
En
English Italiano Français
Nederlands
EspañolDeutsch
Setting the channel levels
You can set the relative channel levels from
your main listening position for each listening
mode, including all the Surround and
Advanced Surround modes.
If you used the Room Setup feature (page 19),
the channel levels for each listening mode
will already be set. However, you can still fine-
tune the levels here if you need to.
1 Press SURROUND or ADVANCED
repeatedly to select a listening mode.
2 Switch the remote control to SUB,
then press TEST TONE to hear the test
tone.
The test tone is output in the following order
(from the speakers active in the current
listening mode):
•
L
– Front left speaker
•
C
– Center speaker
•
R
– Front right speaker
•
RS
– Right surround speaker
•
LS
– Left surround speaker
•
SW
– Subwoofer
3 Use the MASTER VOLUME +/– button
to adjust the volume to an appropriate
level.
4 Use the
/
(cursor up/down)
buttons to adjust the speaker levels in
turn.
You should hear the test tone at the same
volume from each speaker when seated in the
main listening position. The channel level
range is ± 10 dB.
5 When you’re done, press ENTER to exit
test tone setup.
• The speaker volume can be adjusted
while listening to any sound source you
want by pressing
CH LEVEL
and then
using the
/
(cursor up/down) buttons
to adjust the channel levels. After you’re
finished with one channel, use the
/
(cursor left/right) buttons to move to the
next.
• Since the subwoofer produces ultra-low
frequencies its sound may seem quieter
than it actually is.
STANDBY/ON
CD FM/AM
OPEN CLOSEDISPLAY
DVD TUNER TV LINE
L1/L2
4
4
0
DVD MENU
RETURN
SOUND
TV CONTROL
CH VOLINPUT
MUTE
TEST TONE
123
ZOOM
TOP MENU
CH LEVEL
DIMMER
REPEAT
AUDIO ANGLE
RANDOM
SUBTITLE
PROGRAM
4 5 6
789
0
MAIN SUB
FOLDER–
ROOM SETUP
CLR
ENTER
FOLDER+
MENU
HOME
SETUP
SYSTEM
MIDNIGHT
QUIET/
CLOCK
TIMER/
BASS MODE DIALOGUE VIRTUAL SB
AUTO SURROUND
1¡
8
7
3
ENTER
TEST TONE
5
SUB
SURROUND
MASTER
VOLUME
ADVANCED
HTS.book 57 ページ 2003年2月25日 火曜日 午後1時45分