Pioneer AVIC-X9310BT Portable Radio User Manual


 
p When Leftis set, the left speaker output
is delayed. When Rightis set, the right
speaker output is delayed.
Adjusting loudness
Loudness compensates for deficiencies in the
low- and high-sound ranges at low volume.
1 Display the AV Sound Settings
screen.
= For details,refer toDisplaying the screen for
AV sound settings on page 174.
2 Touch [Loudness].
Each time you touch [Loudness], the level is
selected in the following order:
Off Low Mid High
Using subwoofer output
The navigation system is equipped with a sub-
woofer output mechanism, which can be
turned on or off.
p This function is not available when Sub
Wooferis Off.
1 Display the AV Sound Settings
screen.
= For details,refer toDisplaying the screen for
AV sound settings on page 174.
2 Touch [Sub Woofer].
3 Touch [On].
The subwoofer output is turned on.
# If you touch [Off], the subwoofer output is
turned off.
4 Touch [Reverse] or [Normal] to select
the phase of subwoofer output.
5 Touch [+] or [] next to Levelto adjust
the output level.
+6to 24 is displayed as the level is in-
creased or decreased.
6 Touch [c]or[d] next to
Frequency(Hz)to select cut-off fre-
quency.
Each time you touch [c]or[d], cut-off fre-
quencies are selected in the following order:
50Hz 63Hz 80Hz 100Hz 125Hz
Only frequencies lower than those in the se-
lected range are output from the subwoofer.
Using the high pass filter
When you cut lower sounds from the subwoo-
fer output frequency, activate HPF (high pass
filter). Only frequencies higher than those in
the selected range are output from the front or
rear speakers.
1 Display the AV Sound Settings
screen.
= For details,refer toDisplaying the screen for
AV sound settings on page 174.
2 Touch [HPF].
Each time you touch [HPF] selects cut-off fre-
quencies in the following order:
Off 50Hz 63Hz 80Hz 100Hz
125Hz
Adjusting source levels
SLA (source level adjustment) lets you adjust
the volume level of each source to prevent ra-
dical changes in volume when switching be-
tween sources.
p Settings are based on the FM tuner volume
level, which remains unchanged.
p You cannot select [SLA] when the FM tuner
is selected as the AV source.
En
180
Chapter
32
Customizing preferences