Filter
Top Products
EXTERNAL RECORDING
21
Manual recording from an external source
1 Make sure the CDR(W) is absolutely free of scratches and
dust particles.
2 Press repeatedly DIGITAL / ANALOG AUX to select the
input for the external source you want to record from.
yAUX Digital is displayed if the digital input is
selected.
yAUX Analog is displayed if the analogue input is
selected.
3 Press REC TYPE on the set to enter the recording menu.
4 Rotate JOG CONTROL to select the type of recording.
yAUX Manual?: for manual start of recording
5 Press YES to confirm your selection.
yWait is displayed.
yRecord?, AUX and the remaining recording time of
the CDR(W) are displayed.
6
Start playback on the external source in order to set the optimal
recording level on the CD recorder (see “REC LEVEL key”).
7 Stop playback on the external source.
8 Go to the beginning of the desired track.
9 Press YES on the set and simultaneously start playback on
the external source.
yThe CD recorder starts to record and RECORDING IN
PROGRESS is shown. The remaining recording time of the
CDR(W) is displayed.
Note: If Check Input is flashing, check the digital
connection.
10 Press STOP & on the set to stop recording.
yUpdate is displayed and RECORDING IN PROGRESS goes off.
In recording mode tracks will be incremented automatically
such that the track numbers are positioned on the same
position as the original.
• To switch the automatic track increment function on,press
as often as necessary TRACK INCR. on the remote control
during stop when CDR is selected.
yAuto Tr ON is displayed and the function is switched
on. Track increments are now automatically detected
from digital source material. In analogue source material
a silence of 2.7 seconds or more is detected as a track
increment.
• To switch the automatic track increment function off,
press as often as necessary TRACK INCR. on the remote
control during stop when CDR is selected.
yAuto Tr OFF is displayed and the function is
switched off. Track numbers can now be incremented
manually by pressing TRACK INCR. on the remote control
during recording. The minimum track length is 4 seconds.
Notes: – Track numbers cannot be changed after recording.
– The automatic track increment only works with
consumer sources with a digital output signal
according to the IEC 958 (consumer part) audio
standard. DAT, DVD and DCC do not deliver this signal.
Automatic track increment
DO NOT FORGET TO FINALIZE!
Finalizing a CDR(W) disc is a simple procedure, necessary to:
– play a recorded CDR on a standard CD player or
– play a recorded CDRW on a CDRW compatible
CD player and CD recorder.
Manual recording
English