Filter
Top Products
IN-CAR CONNECTION
19
Only use the AY 3545 car
voltage converter (4.5V/600mA,
DC, positive pole to the centre
pin) and the AY 3501 car
adapter cassette. Any other
product may damage the set.
1 Put the CD player on a
horizontal, vibration-free and
stable surface. Make sure it
is a safe place, where the
player is no danger or
obstacle to the driver and passengers.
2 Connect the DC plug of the voltage converter to the 4.5V DC socket of the CD
player (only for a 12V car battery, negative grounding).
3 Insert the voltage converter into the cigarette lighter socket. If necessary, clean the
cigarette lighter socket to obtain a good electrical contact.
4 Turn down the volume and switch off the autoreverse function of your car
radio cassette player.
5 Connect the adapter cassette plug to the p LINE OUT socket of the CD player.
6 Carefully insert the adapter cassette into the car radio’s cassette compartment.
7 Make sure the cord does not hinder your driving.
8 Start the CD player, set VOL E to position 8 and adjust the sound with the car
radio controls.
• Always remove the voltage converter from the cigarette lighter socket when the CD
player is not in use.
Notes: – Avoid excessive heat from the car heating or from direct sunlight (e.g. in a
parked car in the summer).
– If your car radio has a LINE IN jack, it is best to use this jack for the car radio
connection instead of the adapter cassette. Connect the signal lead to this
LINE IN jack and to the p LINE OUT jack of the CD player.
4,5 V DC
DIGIT
AL
DIGIT
AL
DIGIT
AL
P
R
O
G
M
O
D
E
D
B
B
E
S
P
P
/
L
I
N
E
O
U
T
V
O
L
OFF
R
E
S
U
M
E
H
O
L
D
In-car use (connections supplied or optionally available)
English