Filter
Top Products
15
RQT6457
Recording
There are various settings you can change to record in
other ways.
[A] SYNCHRO recording:
To start recording when this unit receives input from
other equipment. Recording pauses when input
stops.
[B] Recording sensitivity:
Lower the level if the level meter frequently reaches
the maximum level when recording from other
equipment.
Raise the level if the level meter barely moves.
[C] Track marking:
Choose how to add track marks when recording
through a microphone or other equipment.
Changing settings
1. Press [MENU] while in the recording standby
mode.
(You can also change these settings while stopped.
You cannot change them while recording.)
2. Press [:] or [9] to select “REC MODE?”.
3. Press [ENTER/MEMORY].
4. Press [:] or [9] to select the mode.
[A] Turning SYNCHRO on
(1) Select “LINE SYNCHRO?”.
(2) Press [ENTER/MEMORY].
(3) Press [:] or [9] to select “LINE
SYNCHRO ON?”.
[B] Setting recording sensitivity
(1) Select “LINE REC SENS?”.
(2) Press [ENTER/MEMORY].
(3) Press [:] or [9] to select the sensitivity.
Each time you press the button:
REC SENS H?: When recording from
:
portable equipment
;
REC SENS L?: When recording from
stereo components
[C] Selecting a marking mode
(1) When recording from other equipment
Select “LINE MARK MODE?”.
When recording through a microphone
Select “MIC MARK MODE?”.
(2) Press [ENTER/MEMORY].
(3) Press [:] or [9] to select the mode.
Each time you press the button:
[>
AUTO: Track marks added when tracks change.
l
:
(when recording from other equipment)
l
;
l>MANUAL: Add marks manually
l
:
(➡ right)
l
;
{>TIME: Marks are added at 3-, 5-, or
10-minute intervals
5. Press [ENTER/MEMORY].
To stop partway
Press [MENU] before step 5.
Note:
While SYNCHRO recording
≥[REC PAUSE] does not respond to touch.
≥The beginning of the track may not be recorded in
some cases. Select “OFF” if this occurs.
∫ MANUAL track marking
Press [ENTER/MEMORY] at the place you want to mark.
≥You can still do this even if you didn’t select MANUAL.
≥You cannot add the next track mark until 2 seconds
have passed since adding the last one.
Other ways of recording