Filter
Top Products
7
RQT5210
Listening
3
2
4
5
7
6
1
1 3 5 2 4 67
Preset channel
Presetting radio broadcasts
•
Up to twelve FM and AM stations each can be programmed.
•
If broadcast frequencies are preset in the memory, you can easily
tune in any of these frequencies.
•
You can preset just those stations you like.
1
Set [ ] to “TUNER”.
2
Press [BAND] to select “FM” or “AM”.
Every time you press the button: FM ↔ AM
3
Press [MEMORY].
“ ” and the frequency flash.
4
While “ ” and the frequency are flashing:
Press [–/g] or [f/
+] to select the desired
station.
“ ” lights when an FM stereo program is being received.
Reference
You can select the desired broadcast by using “Automatic
tuning”. (See page 9.)
5
Press [MEMORY].
“ ” and the preset channel number flash.
6
While “ ” and the preset channel number are
flashing:
Press [–/g] or [f/+] to select the preset channel.
7
Press [MEMORY].
If the “ ” indicator goes off during programming, return to
step 3.
Repeat steps 3 to 7 to program other stations.
RX-D11 only
When using the remote control
Preparation: Set [ ] to “TUNER”.
1. Press [BAND] to select “FM” or “AM”.
2. Press [MEMORY/PGM].
3. While “ ” and the frequency are flashing:
Press [–/g] or [f/+] to select the desired station.
4. Press [MEMORY/PGM].
5. While “ ” and the preset channel number are flashing:
Press [3] or [4] to select the preset channel.
6. Press [MEMORY/PGM].
Repeat steps 2 to 6 to program other stations.