Filter
Top Products
12
RQT5210
Listening
1
A
2
3
4
3 2
1 4
B
XBS
Listening to tapes
Types of tapes which can be played correctly:
Normal position/TYPE I
High position/TYPE II ✕
Metal position/TYPE IV ✕
High position and metal position tapes can be played, but the unit will
not be able to do full justice to the characteristics of these tapes.
1
Set [ ] to “TAPE/ ”.
2
Press [L/c STOP/EJECT], load the tape and close
the tape lid.
3
Press [
- -
- -
- PLAY] to start play.
Adjust the volume.
To stop play:
Press [L/c STOP/EJECT].
To stop play temporarily:
Press [J PAUSE].
To resume play:
Press [J PAUSE] again.
The unit’s power is on in the pause mode. Stop tape to turn the unit
off by pressing [L/c STOP/EJECT] when leaving the unit.
To fast-forward or rewind the tape A
Press [( REW/REV] (backward) or [) FF/CUE]
(forward) in the stop mode.
Note
Do not press [-PLAY] when rewinding or fast forwarding, as this may
jam the tape.
Be sure to press [L/c STOP/EJECT] before the next operation.
To find a particular spot on a tape A
Press [( REW/REV] (backward) or [) FF/CUE]
(forward) during playback.
Tape play is resumed when the button is released.
Full auto-stop:
The automatic stop system will release the buttons when the tape
reaches the end during play or when recording, fast forwarding or
rewinding.
Changing the sound quality
Adjusting the deep-bass (XBS)
Press [XBS] to boost the bass sounds.
Every time you press the button: XBS ↔ OFF
B
Side to be played facing upward.
Insert the tape with the exposed tape facing you.