Filter
Top Products
E-42
Setting
Ⅵ REMOTE switch on the front panel
To use the wireless remote controller, set the switch to “WIRELESS”.
Ⅵ SYSTEM menu
• STILL MODE
Use this to select the image type for still image playback or frame
advance playback.
(Field image, 1st field image, 2nd field image and frame image)
Note: Still images can also be selected with the STILL MODE
button of the wireless remote controller.
• STILL TIMER
Use this menu item to set the time interval, after the lapse of
which, the unit will go into the tape protection mode.
(5, 3, 2 or 1 minute, 30 seconds)
• PAUSE PROTECT MODE
Use this mode to select the operation state when tape protection
mode is engaged after an extended period of being in the STILL
mode. (F.ADV or STBY-OFF)
Ⅵ AUDIO/VIDEO menu
• A. OUT AT SEARCH
Use this menu item to turn ON/OFF audio output during variable
speed playback.
• AUDIO OUT SEL
Use this menu item to select the output audio channel when play-
ing tapes recorded in the 32kHz mode. (CH1/2, CH3/4, MIX)
• AUDIO OUT LEVEL
Use this menu item to select the standard level for audio output.
(NORMAL.ATT)
To reduce the AUDIO output level, set to ATT.
• SETUP (NTSC only)
Use this setting to determine whether to apply the setups to the
composite video or Y/C separate video output signals.
RE
C
PA L
AUDIO
NTSC
DVCAM
POWER
A.DUB
CH
1 / 3
2 / 4
LINE
DV
S-VIDEO
OFF
9PIN
WIRELESS
INPUT
REMOTE
MIC
AG-DV2500
REMOTE switch
–––SYSTEM–––
STILL MODE FIELD
SERIES REC TIME OFF
STILL TIMER 5MIN
PAUSE PROTECT F.ADV
INDEX
W
RITE ON
DC IN MODE PO
W
ER OFF
PAGE BACK
AUDIO VIDEO
AUDIO MODE 48K
AOUTATSEARCH ON
AUDIO OUT SEL CH-1/ 2
AUDIO OUT LEV NORM
SET UP(NTSC) OFF
PAGE BACK
SYSTEM menu
AUDIO/VIDEO menu
Memo
To control the unit with the 9 PIN REMOTE terminal, set the switch
to “9PIN”.
Memo
AUDIO OUT SEL or AU-
DIO OUT LEVEL items
can also be set via the
AUDIO OUT SEL or AU-
DIO OUT LEV button on
the wireless remote con-
troller.
PLAYBACK – Connection/setting –
Memo
Audio recording level
PCM audio recording level of DV-format VTRs can be divided into 2 main groups:
1) The group that uses full scale -20dB as the standard level, to which this unit belongs.
2) The group that uses full scale -12dB as the standard level.
When a tape recorded with a VTR based on full scale -12dB is played on this unit, the volume is
increased by about 8dB. In this case, set the AUDIO OUT LEVEL menu item to ATT.