Filter
Top Products
14
1
EN
Power supply
Power supply
• Do not use USB extension cables other
than the supplied cable.
Using cables from other manufacturers
could result in damage to the recorder. Do
not use the supplied USB extension cable
with devices from other manufacturers.
Cautions concerning the rechargeable batteries
Read the following descriptions carefully
when you use the Ni-MH rechargeable
batteries.
Discharging:
The rechargeable batteries self-discharge
while this is not in use. Be sure to charge
them regularly before use.
Operating temperature:
The rechargeable batteries are chemical
products. The rechargeable batteries
efficiency may fluctuate even when
operating within the recommended
temperature range. This is an inherent
nature of such products.
Recommended temperature range:
When operating appliance:
0°C - 42°C/ 32°F - 107.6°F
Charging:
5°C - 35°C/ 41°F - 95°F
Storage for a long period:
–20°C - 30°C/ –4°F - 86°F
Using the rechargeable batteries outside
the above temperature range may result in
declining efficiency and shorter battery life.
In order to prevent battery leakage or rust,
remove the rechargeable batteries from the
products when you will not be using them
for a long time, and store them separately.
• If [USB Connect] has not been set
to [AC Adapter], [Please wait] will
continue to be displayed (☞ P.61).
4 Charging is completed when
battery indication becomes to [¿].
Notes
• The recorder cannot be charged when
the PC is not turned on. Also, it may not
be charged when the PC is not switched
on, or when it is in the standby, hibernate
or sleep mode.
• Do not charge the recorder with the USB
hub connected.
• Insert the supplied rechargeable battery
and set [Battery] to [Ni-MH]. If [Battery]
is set to [Alkaline], you cannot recharge
(☞ P. 12).
• You cannot charge when [ø]*1 or [√]*2
blinks. Charge the batteries at the
temperature from 5°C to 35°C (41°F to
95°F).
*1 [ø]: When surrounding temperature is
low.
*2 [√]: When surrounding temperature is
high.
• When using time becomes notably short
even after the batteries are fully charged,
replace them with new ones.
• Be sure to push the USB connector all the
way in. Otherwise, the recorder may not
operate properly.
• Use the supplied USB extension cable
depending on situations.
3 Press the
OK
`/
MENU
button to
start charging.