Filter
Top Products
7
2. Check to make sure your SoundBridge software is running v. 2.0 or later using the “Check
for new software” command in the “System Configuration” menu. SoundBridge will then
reboot. (See page 15 for additional instructions on updating your SoundBridge software.)
3. Continue to Section II, “Hooking Up Your Home Network Hardware,” below.
II. Hooking Up Your Home Network Hardware (Wired Ethernet or Wireless)
Please remove the left end cap of your SoundBridge to connect your Ethernet cable or your
wireless adapter (never both at once; connecting both may cause your connection not to
work). Note that both end caps have a hole for routing your cables toward the back of the unit.
Wireless Connection: Insert the Wi-Fi adapter card (included with most SoundBridge models)
into SoundBridge. It should be inserted into the CompactFlash card slot with the Roku label
facing toward the back of the unit, and toward the Ethernet jack. Close the end cap by
snapping it securely into place.
Ethernet Connection: Plug your cable into the jack provided. Connect your Ethernet cable
to a hub, switch or router in your home network. Alternatively, you can connect SoundBridge
directly to your computer (and bypass a hub/switch/router), but only with a “crossover” cable
(not included). Close the end cap by snapping it securely into place. Connect the other end of
the cable to your network.
Please note that not all wireless CF adapters are compatible with SoundBridge. If your unit
did not include a Wi-Fi adapter, Roku offers a compatible adapter for sale on our web store,
www.rokulabs.com/buy. You can also find a list of supported wireless CF adapters and wireless
network access points in our support area.
III. Hooking Up Your Speakers or Stereo System
Both end caps of your SoundBridge unit are removable. The right end cap covers the audio
connectors and AC power connector, the left one holds an Ethernet connector and your Wi-Fi
Network adapter CompactFlash slot (Wi-Fi adapter may be sold separately depending on your
SoundBridge model).
Remove the right end cap to connect audio cables by gently pressing on the flat part of the end
cap, while pressing on the two dimpled tabs in the back, and pivot the cap backward.