6
INSTALLATION
Unravel the AC cord and connect it to a
conveniently located AC outlet having 120V
and 60Hz only. The Clock Display will
illuminate and “12:00” will blink in the window.
NOTE: If the AC plug does not fit into a
nonpolarized outlet, do not file or cut the wide
blade.
If the AC cord is disconnected or if there is a
power failure, this electronic clock is designed
to continue operating internally (without showing the time on the Clock Display)
with a 9 volt battery (not included). To install the battery, connect the battery to
the terminals of the battery snap inside the compartment (use of an alkaline
battery is recommended).
Be sure to check the condition of the battery periodically by disconnecting the AC
cord and connecting it again two or three minutes
later. The preset times should continue operating. If
the present time does not appear, it indicates the
battery is dead or not connected properly. The 9 volt
battery will keep the internal times accurately for
approximately 30 minutes. If the power is restored
after 30 minutes, the times may need to be reset.
BATTERY PRECAUTIONS
Follow these precautions when using batteries in this device:
1. Use only the size and type of batteries specified.
2. Be sure to follow the correct polarity when installing the batteries as indicated in the
battery compartment. Reversed batteries may cause damage to the device.
3. If the device is not to be used for a long period of time, remove the batteries to prevent
damage or injury from possible battery leakage.
4. Do not try to recharge batteries not intended to be recharged; they can overheat and
rupture. (Follow battery manufacturer’s directions.)
MMG-CR2900.OM.QXD 9/9/02 9:22 AM Page 6