Filter
Top Products
Matrox TripleHead2Go – User Guide 7
Connecting your TripleHead2Go Digital
Edition product
This section describes how to connect up to three (3) analog or digital monitors to your Matrox
product.
To connect three (3) monitors, see “Connecting three monitors”, page 8.
To connect two (2) monitors, see “Connecting two monitors”, page 11.
Before you begin
To avoid possible problems that could damage your monitors or prevent you from using your Matrox
product, read the following guidelines before connecting your Matrox product.
Whenever you change your connection setup, make sure you’re using the correct
connectors and that all connectors are properly fastened.
Don’t change monitor connections while your computer is turned on. While your
computer is turned on, it may be using monitor settings that are specific to the current
monitor connections.
Some
devices may be permanently damaged if incorrect settings
are used.
To get the most out of your Matrox product, we recommend you use three (3) identical
monitors (that is, monitors that support the same settings such as display resolution and
refresh rate). For information on the settings your monitor supports, see your monitor
documentation.
While using the DVI input connector on your Matrox product, the highest display
resolutions are available only with graphics hardware that supports dual-link DVI. For
information on the capabilities of your graphics hardware, see its documentation. For
more information on your Matrox product, see “Product information”, page 42.
Note:
To purchase any cables or adapters not included with your Matrox product, see the
Matrox online store (shopmatrox.com
).