Starting and shutting down the projector
1. Connect the power cord to the projector. Connect the other end to a wall outlet. This turns on the
POWER and READY LEDs on the projector.
2. Turn on the connected devices.
3. Ensure that the Ready LED is on a steady (not flashing) orange and then press the Power button to
turn on the projector. The projector splash screen displays and connected devices are detected. If the
connected device is a PC, press the appropriate keys on the computer keyboard to switch the display
output to the projector. (Check the user manual of the PC to determine the appropriate Fn key
combination to change display output). See ″Navigating the OSD on “Navigating the OSD” on page
3-1 if Security Lock is enabled.
4. If more than one input device is connected, press the Source button repeatedly to switch among
devices. DVI and component video are supported through the DVI-I connector.
5. To turn off the projector, press the Power button. The projector prepares for shutdown and a ″Wait a
moment please...″ message appears.
6. When the ″Power Off?/Press Power again″ message appears, press the Power button. The projector
turns off.
Note: This projector has a fast shutdown cycle to let you unplug the projector. However, to allow proper
cooling of the bulb, the projector will not turn on again for 60 seconds.
Attention: Do not unplug the power cord until the Ready LED stops flashing, indicating the projector
has cooled down.
Chapter 2. Setup and Operation 2-3