Filter
Top Products
6
NOTE: Fog and mist will not harm your temperature sensor, but direct rain must be
avoided.
DETAILED SETUP GUIDE
BATTERY INSTALLATION
- When one Temperature sensor is being used
1. First, insert the batteries to the Temperature sensor (see “Temperature
sensor” below).
2. Within 2 minutes of powering up the sensor, insert the batteries to the
Temperature Station (see “Wireless Temperature station” below). Once the
batteries are in place, all segments of the LCD will light up briefly. Following
the indoor temperature and the time as 12:00 will be displayed. If they are
not shown in LCD after 60 seconds, remove the batteries and wait for at least
60 seconds before reinserting them. Once the indoor data is displayed user
may proceed to the next step.
3. After the batteries are inserted, the Temperature Station will start receiving
data signal from the sensor. The outdoor temperature should then be
displayed on the Temperature Station. If this does not happen after 2
minutes, the batteries will need to be removed from both units and reset from
step 1 and the signal reception icon is no longer shown.