Filter
Top Products
12
LCD will light up briefly. Following the indoor temperature and the time as
12:00 will be displayed. If they are not shown in LCD after 60 seconds,
remove the batteries and wait for at least 60 seconds before reinserting
them.
4. The outdoor temperature from the first sensor (channel 1) should then be
displayed on the Temperature station. If this does not happen and the signal
reception icon is not shown, after 2 minutes, the batteries will need to be
removed from both units and reset from step 1.
5. Insert the batteries to the second sensor as soon as the outdoor temperature
readings from the first sensor are displayed on the Temperature station.
NOTE: You must insert the batteries into the second sensor within 45
seconds of reception of the first sensor.
6. The outdoor temperature from the second sensor and the "channel 2" icon
should then be displayed on the Temperature station. If this does not happen
after 2 minute, the batteries will need to be removed from all the units and
reset from step 1.
7. Insert the batteries to the third sensor as soon as the "channel 2" icon and
outdoor data are displayed on the Temperature station. Then within 2
minutes, the channel 3 outdoor data from the third sensor will be displayed
and the channel icon will shift back to "1" once the third sensor is