Filter
Top Products
9
WWVB search every night between these hours and overrides any
manually set time. The WWVB tower icon (appearing in the TIME
LCD) will flash when a signal-search is in progress, will remain
steady when the signal has been received, and nothing will be
displayed in all other situations. If the WWVB time has not been
received 10 minutes after battery installation you may manually set
the time or wait for WWVB reception. Once the WWVB time
signal is received it will override the manually set time.
2. Manual Time Setting
a. Press and hold the “SET” button for 3 seconds or
until “12h” or “24h” flashes in the DATE LCD.
b. Press and release the “SET” button 3 times.
c. The hour digit will be flashing in the TIME LCD.
d. Press and release the “CH” button to change the
hour – increasing the hours by increments of 1 with
each press of the “CH” button.
e. Press and release the “SET” button to confirm the
hour setting and to advance to the minute setting
mode.
f. The minute digits should be flashing. Press and
release the “CH” button to change the minutes—
increasing the minutes by increments of 1 with each
press of the “CH” button.
g. Press and release the “SET” button to confirm the
minutes and to advance to the Day, Date, and Year
setting mode.
Note:
In 12h mode, “PM” will appear to the left of the time
during PM hours. If the time is not within the PM hours, nothing
will be displayed. Be sure to set the time to the correct AM/PM
time to ensure automatic reception at optimal times.
E. Setting the Day, Date, and Year
Note:
“MO” (representing Monday) is the default (factory) setting
for the weekday, “1.1” is the default (factory) setting for the
numeric month and day, and “1999” is the default (factory) setting