Filter
Top Products
17
The WS-7078UF is able to receive signals from as many as 3 different
remote thermo/hygro sensors. The remote sensor model(s) that you choose
will come with their own set of instructions, follow these instructions for a
complete guide to setting up. Following are some brief instructions for the
basic set-up of remote sensor units with the WS-7078U. These extra remote
sensors can be purchased through the same dealer as this indoor weather
station or by contacting La Crosse Technology directly. A TX4U will
monitor temperature and humidity, a TX3U will monitor temperature only,
and the TX3UP will monitor water or soil temperature via a probe.
Note:
When setting up multiple remote sensors it is important to remove
the batteries from all existing units in operation, then to insert batteries
first into all the remote sensors. Second install batteries into the indoor
weather station. Transmission problems will arise if this is not done
correctly and if the total time for set-up exceeds 6 minutes.
A. Set-up of Multiple Units
1. It is necessary to remove the batteries from all units
currently in operation.
2. Remove the battery covers to all remote sensors.
3. Place all remote sensors in a numeric sequential order.
4. In sequential order, install batteries following the same
battery installation procedures seen in Detailed Set-Up
Guide section of this manual.
5. Install batteries into the indoor weather station.
6. Follow the Detailed Set-Up Guide for programming and
operating instructions.
B. Viewing and Operating with Multiple Thermo/hygro
Sensors
1. To view the temperature of a different remote
thermo/hygro sensor press and release the “CH” button.
A shift from one “boxed” number to the next should be
observed in the OUTDOOR LCD.
2. To view the Minimum/Maximum temperature of a
different remote thermo/hygro sensor, first select which
remote thermo/hygro sensor to read data from (indicated