Filter
Top Products
POWER
POWER
B
ASS
TREBLE
VOLUME
AUX
INPUT
7
8
8
6
6 Krell
/Papa Dock
P
lacement Considerations,
continued
The KID / Papa Dock Connection
C
omponent Ventilation,
c
ontinued
If the KID is placed in a closed cabinet, more than
eight inches (20 cm) of clearance may need to be
provided above and below the component, or
small fans may be needed to increase ventilation.
To connect the KID to the Papa Dock:
1. Remove the connector plate from the bottom
of the KID, using the T-10 Torx wrench
provided in the Papa Dock accessory box.
2. Place the KID and the Papa Dock side-by-
side, with the front panel facing toward you.
3. Lift the KID up and position it over the con-
nection well (6) in the Papa Dock.
4. Lower the KID gently but firmly onto the
Papa Dock docking connector (7).
The air space between the chassis and shelf must
b
e unobstructed.
T
he Papa Dock requires ventilation clearance:
— at least two inches (5 cm) above, below, and
on each side.
PLACEMENT CONSIDERATIONS, c
ontinued
THE KID / PAPA DOCK CONNECTION
To disconnect the KID from the Papa Dock:
1. Facing the front of the two components, insert
your fingers in the plunger holes on the bottom
panel of the Papa Dock.
2.
Push up both plungers (8) simultaneously. The
plungers elevate the KID, disconnecting it from
the Papa Dock.
3. Lift the KID out of the connection well on the
Papa Dock, and set the KID aside.
5
FIGURE 2 Connecting the KID to the Papa Dock