Filter
Top Products
• “High” is 0dB, “Medium” is –3dB and “Low” is –6dB.
Note: To avoid distortion with some cassette car stereos, you may have to lower the output level when using
the cassette adapter.
Antenna Signal
This screen shows the quality of the SIRIUS satellite signal that’s being received, to help you find the best
location for the antenna.
1. While in the Setup Mode, press the left or right arrow
button until the Antenna Signal screen appears (right):
• After a few seconds the signal quality bars will
indicate how well the antenna is receiving the
SIRIUS satellite signal.
2. Find a location for the antenna that illuminates the
maximum number of bars.
• After moving the antenna, wait at least 2 seconds before moving it again, to enable the unit to process
the signal.
3. Due to the moving paths of the SIRIUS satellites, it is possible for the signal to change over time. In most
cases, signal should be available continuously, however, it may be temporarily blocked in some antenna
locations in home installations. Be sure to check the the Antenna Signal screen if there is a loss of
signal or audio. Experimentation with antenna placement in the home or outside may be necessary to
ensure continuous reception.
• See pg. 11, Step 5 for information about locating the SIRIUS antenna in a home installation.
Here
2
Anywhere Instruction Manual
25
8. Press the MEMORY button. The display will change to “New Code Confirmed”
• If you entered the code incorrectly, “Code Error” will be displayed, and the Enter New Lock Code screen
reappears. Repeat Steps 5 – 8.
Startup Mode
You can select which screen is displayed when you turn
Here
2
Anywhere’s power on.
1. While in the Setup Mode, press the left or right arrow
button until the Startup Mode screen appears (right):
2. Use the up & down arrow buttons to highlight the
screen you want for Startup: Normal Operation,
Channel List (Stream List) or Category List:
3. Press the
SELECT button.
Output Level
You can adjust
Here
2
Anywhere’s output level so it matches other
sources in your audio system.
1. While in the Setup Mode, press the left or right arrow
button until the Output Level screen appears (right):
2. Use the up & down arrow buttons to select the
desired output level.
Here
2
Anywhere Instruction Manual
24
Normal Screen
Stream List Screen
Category List Screen
Output Level Screen
Antenna Signal Screen
Startup Mode Screen