Filter
Top Products
13
first program “ ” will light up and blink continuously. Press the
FOLDER UP " or DOWN & BUTTON and then press CD SKIP/SEARCH
FORWARD % or BACKWARD $ BUTTON to select your desired music
track. The LCD DISPLAY will show the track number of this specific
Album to be programmed. Press the PROGRAM BUTTON to store this
track in memory.
2. Repeat above procedure until all desired tracks have been programmed.
Remarks: Whenever the FOLDER UP
"
or DOWN
&
BUTTON is
pressed, it will always show the last programmed Album
number first to recall your memory.
A total of 20 tracks can be stored in memory. After completion of the
programming of all the 20 tracks, the LCD DISPLAY will show
“
” and blink continuously.
3. To start the Programmed playback, press the CD PLAY/PAUSE "#
BUTTON once and the CD Play Indicator “
"
”, “PROGRAM”, “MP3”
Indicator and the track number of the specific Album will light up.
4. To check the program you have stored after programming, press the
PROGRAM Button once. “PROGRAM” and Program No. “
” will light
up and blink.
5. Press the CD SKIP/SEARCH FORWARD % BUTTON to view the
programmed track of the Album and then press FOLDER UP "or DOWN
& Button to view the Album number.
Example : Album # 3, Track # 2.
6. Repeat the procedure in steps 3 & 4 above to view the rest of the
programmed track and Album one by one.
7. To cancel the programmed memory :
i. During CD stop mode, press the CD STOP ! BUTTON once.
OR
ii. Open the CD Door during CD stop mode.
The “PROGRAM” Indicator will disappear from the LCD DISPLAY.
USB OPERATION
1. Slide the FUNCTION SWITCH to “CD”.
NOTE: Make sure no disc is located inside the CD compartment.