Jensen JCR-310 Clock Radio User Manual


 
13
CARE AND MAINTENANCE
1. Avoid operating your unit under direct sunlight or in hot, humid or dusty places.
2. Keep your unit away from heating appliances and sources of
electrical noise such as fluorescent lamps or motors.
3. If drop-outs or interruptions occur in the music during CD
play, or if the CD fails to play at all, its bottom surface may
require cleaning. Before playing, wipe the disc from the
center outwards with a good soft cleaning cloth.
4. Unplug the unit from the electrical power outlet immediately in
case of malfunction.
Cleaning the Unit
To prevent fire or shock hazard, disconnect your unit from the AC power source when
cleaning.
The finish on the unit may be cleaned with a dust cloth and cared for as other
furniture. Use caution when cleaning and wiping the plastic parts.
If the cabinet becomes dusty wipe it with a soft dry dust cloth. Do not use any wax or
polish sprays on the cabinet.
If the front panel becomes dirty or smudged with fingerprints it may be cleaned with a
soft cloth slightly dampened with a mild soap and water solution. Never use abrasive
cloths or polishes as these will damage the finish of your unit.
CAUTION: Never allow any water or other liquids to get inside the unit while cleaning.
TROUBLESHOOTING GUIDE
If you experience difficulties in the use of this Docking System, please check the following
or call 1-800-777-5331 for Customer Service.
Symptom Possible Problem Solution
AC power cord is not plugged
properly into a wall outlet or
the connector is not plugged
into the AC Socket on the
back of the System.
Re-plug the
AC power
cord into the wall outlet
and the connector into AC
Socket on the System.
Unit does not
respond (no power)
Wall outlet is not functioning. Plug another device into
the same outlet to confirm
the outlet is working.
Radio no sound
Unit not in RADIO function
mode.
Volume set at minimum
Tap FUNCTION button to
AM/FM RADIO position.
Increase Volume
Noise or sound
distorted on AM or
FM broadcast
Station not tuned properly for
AM or FM.
FM: Wire antenna is not fully
extended.
AM: The reception at the set
location is poor.
Retune the AM/FM broadcast
station.
FM: Fully extend or reposition
the FM wire antenna.
AM: Change the position for the
best reception.