Filter
Top Products
10
Recalling a Preset Station
1. Tap the / FUNCTION button to turn on the unit.
2. Tap the / FUNCTION button to select AM or FM radio receiving mode.
3. To select desired preset channel, tap the MEM+ button repeatedly.
CD OPERATION
This CD player not only plays commercial CDs, but also self-compiled CD-R/RW discs. Do
not attempt to play any of the following formats: CD-ROM, CDI, VCD, DVD or computer
CDs.
NOTES ON CD-R/RW DISCS
• Because of non-standardized format definition/production of CD-R/RW, playback
quality & performance are not guaranteed.
• Manufacturer is not responsible for the playability of CD-R/RW due to recording
conditions such as PC performance, writing software, media ability, etc.
• Do not attach a label or seal to either side of the CD-R/RW disc. It may cause a
malfunction.
INSERTING AN AUDIO CD DISC
1. Press the OPEN button to open the CD door. Carefully place an audio CD disc with
its label side facing upward in the CD compartment and gently
close the CD door.
2. Tap the / FUNCTION button to turn on the unit.
3. Tap the / FUNCTION button to select CD mode.
4. The unit will read the CD disc automatically, display will briefly
show flashing “- -” then the total number of tracks on the CD.
5. If no disc is inserted or if the inserted disc is not recognized, the
display will show the message “NO”. If the CD door is not closed, the display will
show “OP”.
NOTES:
Keep the CD door closed when the system is not in use to prevent dirt and dust from
entering the CD mechanism.
Never place more than one CD in the CD tray. If two discs are loaded at the same
time, the CD mechanism may jam and / or the discs themselves may be damaged.
AUDIO CD DISC PLAYBACK
1. When the CD door is closed and a CD is inside, press the PLAY/PAUSE button
to start CD playback.
2. Adjust the VOLUME control to obtain the desired sound level from the Built-in
Speakers.
IMPORTANT!!
If the disc is smudged or scratched it may skip or stop completely. This does not indicate a
problem with the player. If this occurs, try playing another disc. If that disc plays properly,
you may assume that the first disc is damaged and unplayable.
PLAY/PAUSE MODE
1. To temporarily stop playback while the CD disc is playing, press the button once.
The track number playing will be flashing, playback is now paused.
2. The sound pauses, but the disc will continue to spin. To re-start playback, press the
buton again. The music will start from the exact position where it was paused.