Jensen JCR-310 Clock Radio User Manual


 
12
SLEEP TIMER FUNCTION
The sleep timer allows you to turn the unit off after a designated time is reached.
1. To activate the sleep timer, turn the unit on and either load a CD, tune to the desired
radio station or listening to music via AUX IN.
2. Tap the SLEEP button and the sleep time appears on the display.
3. Repeatedly tap the SLEEP button to select a sleep time. The unit will turn off after 10,
20, 30, 40, 50, 60, 70, 80 or 90 minutes. Wait 5 seconds after your selection for the unit
to confirm the selection, the unit will play for the selected length of time then
automatically turn off.
4. To cancel the sleep timer, press the SLEEP buttons until timer shows “OFF”, the unit
will turn into standby mode after 2 seconds.
5. To turn the unit off before the selected length of time, press the Power
button at any
time.
Notes:
1.) To check the remaining sleep time, tap the SLEEP button once.
2.) If you are falling asleep to music from an external device connected to the AUX
input, the sleep timer will shut off the power to this system but it will not turn off the
external device.
AUXILIARY INPUT OPERATION
This unit provides an auxiliary audio signal input jack for connecting external audio
devices like MP3 players, CD players and iPods (except iPod shuffle 3rd gen) and listen
to your external source through the speakers of this system.
1. Use an audio cable (not included) with one 3.5 mm stereo plug on each end of the
cable.
2. Plug one end into the AUX-IN jack located on the left hand side of the unit and the
other end of the cable into the Line-out Jack or Headphone Jack of your external
audio device.
3. Turn on the external audio device.
4. Tap the / FUNCTION button to select AUX mode, “AUH” will show on display for
few seconds before show current time.
5. The volume level can now be controlled through the main unit. Operate all other
functions on the auxiliary device as usual.
Note:
(1) If you connected the Line-out Jack of your external device then you only need to
adjust the volume control of this system. If you connected the Headphone Jack of
your external device then you may need to adjust both the volume control of your
external device and the volume control of this system to find the most desirable
volume setting.
(2) Remove the audio cable from AUX IN jack when you finish listening. Don't forget to
switch off the power on your external device as well.