Filter
Top Products
CHANNEL MEMORY PROGRAMMING (Without a Cable Box)
19
The video output channel of this unit is set to channel 3 prior to shipment from the
factory.
INPUT SELECT
To use the external input jack, select the AUX position. Press CHANNEL " " or " "
button or enter "00" with number button so that "AUX" appears on the screen.
VIDEO MODE SELECTION ON TV
TV power must be on. Please see your TV's owner's manual for details.
To Set your TV to the Video Mode
Connection Using AV cord (Refer to page 14.): Set your TV to the Video Mode using
VCR/TV button on you TV. To set your TV to the TV mode, press VCR/TV button of
your TV again.
Connection Without AV Cord (Refer to page 12, 13, 15): Set the TV channel to the
same video output channel located on the back of the VCR. (CH 3 or 4) Then, set your
VCR to the VCR mode using VCR/TV button of your VCR.
CHANNEL MEMORY PROGRAMMING (Without a Cable Box)
Channel memory programming is NOT needed when connected to a CABLE BOX. You
can program the tuner to scan only the channels you receive in your area. See page 31
for channel designations.
You must use remote control for this procedure.
NOTES:
Follow the steps below, once. Repeat it only if there is a power failure or the VCR is
unplugged for more than 30 seconds. In these cases, since the programmed channels are
erased, the VCR will prompt you with "--:--" when you turn it on.
You must follow the steps below before attempting to play or record a video tape. If you
want to play ore record a video tap BEFORE programming the tuner, you must first press