Filter
Top Products
Check all the TV and VCR functions. If you don't get all the functions you
want, proceed with Option 3.
Option 3--Some Channels Scrambled
This hookup requires three coaxial jumpers with connectors, a 1-into-2
splitter, and an A-or-B switch box.
1. Disconnect the cable from the cable box and attach it to the input line of
the 1-into-2 splitter.
2. Using a coaxial jumper, reconnect one of the splitter outputs to the cable
box's input that you just freed up.
3. Using a second coaxial jumper, connect the other splitter output to the A of
the A-or-B switch.
4. Using the cable box output line, connect the cable box receptacle to the B
of the A-or-B switch.
5. Using a third coaxial jumper, connect the output of the A-or-B switch to the
input of the VCR.
6. Take the coaxial cable that is still connected to the television and hook it to
the output of the VCR.
Some Channels Scrambled Cable Box Hookup
This setup lets you switch between the two configurations in Options 1 and 2.
Check all the TV and VCR functions. If you still don't get the functions you
want, proceed with Option 4.
Option 4
If none of the preceding hookups work, check with your cable company. You may
need to purchase a video switching system from your local electronics or video
retailer. This will easily handle most hookup problems.
Remote Control of the Cable Converter
If you have a cable converter, you will probably want to program your VCR's remote
control so you can easily change channels. The process is the same as for
programming the remote to operate your TV. For additional details, see page 40.
Hold down the CATV button and press the number of your brand of cable box
(shown in the chart).
If that button combination does not work, or if your brand is not on the chart, just go
through all the button combinations until you find the one that works best.