Filter
Top Products
If you have no jacks like these on your TV, skip this step and proceed to Step
4.
TV with Audio and Video Jacks
If you do find all three jacks on your TV, you need to purchase a three-line
audio/video cable with bell (RCA) connectors, like this:
If you find a video jack and only one audio jack, your TV is probably
monaural. You can purchase a two-line audio/video cable, but the three-line
is handy in case you get a stereo TV later.
Connect the yellow VIDEO OUT jack on the VCR to the VIDEO IN jack on
the TV.
This direct video input will give you the best picture. It will also let you play
videos in a "picture in picture" feature, if your TV has it.
Then connect the AUDIO OUT jacks (red and white) on the VCR to the
AUDIO IN jacks on the TV (left to left, right to right).
This audio hookup will give you better sound than the RF signal hookup,
because the electronic signal won't have to go through a conversion process.
Plus your VCR has a stereo decoder, which your TV might not. For big
speaker sound, you can also use these jacks to connect the VCR to your
stereo system (page 46).
Capabilities: The audio and video signal connections are all you need to play
back a prerecorded tape. If you do not intend to record on your VCR from
your antenna/cable, then you're all hooked up now. Otherwise, continue with
Step 4, which will let you record off TV channels.
4 Hook Up the RF Signal
Look at the back of your TV for a connector that looks like one
of these, and follow the corresponding hookup option. If you have any sort of
cable box, see the hookup options in Advanced Operations (page
50).
2
Actually page 42
Simple Antenna/Cable 75 Ohm Hookup
This is an easy hookup that you can use if your cable or antenna has a 75
ohm round wire connector. You will need the 75 ohm cable supplied with
your VCR. It looks like this: