Filter
Top Products
46 Auto LUN XP for the XP12000/XP10000
• When you try Auto LUN XP migrations or migration cancellations using RAID Manager, EX_CMDRJE
might appear and the command might be refused, depending on the condition in the disk controller.
Table 13 shows error codes, causes, and solutions for this case.
Table 13 Errors during Auto LUN XP migrations or migration cancellations using RAID Manager
Error code Cause Solution
2051 Migration target volume is being used with LUN
Security XP Extension.
Release the volume from LUN Security XP
Extension, and perform the volume migration.
2055 Migration target volume is being used with
Continuous Access XP Journal.
Release the volume from Continuous Access XP
Journal, and perform the volume migration.
2056 Migration source volume is being used with
Continuous Access XP Journal.
Release the volume from Continuous Access XP
Journal, and perform the volume migration.
2057 VMA setting is different between the migration
target and source volumes.
Volume migration cannot be executed. Check the
configuration definition file.
2058 Migration target and source volumes belong to
the same parity group.
Volume migration cannot be executed. Check the
configuration definition file.
2301 Auto LUN XP is not installed on the
XP12000/XP10000.
Install Auto LUN XP, and perform the volume
migration.
2306 LBA size does not match between the migration
target and source volumes.
Volume migration cannot be executed. Check the
configuration definition file.
2309 Maximum number of pairs that can be set in the
disk array is exceeded.
Reduce the number of pairs set in the disk array,
and perform the volume migration (see
”Calculating the number of Auto LUN XP
concurrent migration plans”).
2311 Auto LUN XP already reserved the migration
target volume.
Cancel the Auto LUN XP reservation, and perform
the volume migration.
2312 Migration source volume is online with the host. Take the migration source volume off-line from the
host, and perform the volume migration.
232F Migration source volume is already specified as
an Auto LUN XP target volume.
Release the volume from Auto LUN XP, and
perform the volume migration.
2331 Consider the following causes:
• Auto LUN XP already reserved the migration
source volume.
• Number of slots in the migration target and
source volumes does not match.
Do the following:
1. Cancel the Auto LUN XP reservation, and
perform the volume migration.
2. Volume migration cannot be executed. Check
the configuration definition file.
2332 You cannot add pair settings any more to the
migration source volume.
Reduce the number of pair settings of the
specified volume, and perform the migration (see
”Calculating the number of Auto LUN XP
concurrent migration plans”).
2333 Volume specified by the migration cancellation is
not a migration source volume.
RAID Manager is trying to perform the migration
cancellation for a pair that is not migrating.
Check the configuration definition file.
2336 Emulation type of the migration target and source
volumes does not match.
Volume migration cannot be executed. Check the
configuration definition file.
2337 Migration source volume is a Business Copy XP
leaf volume.
Release the Business Copy XP pair, and perform
the volume migration.
233B Migration target volume is a Business Copy XP
primary volume.
Release the Business Copy XP pair, and perform
the volume migration.
233C Migration target volume is a Business Copy XP
secondary volume.
Release the Business Copy XP pair, and perform
the volume migration.