Filter
Top Products
Follow this procedure to set your clock for a Go tournament game:
1. Level GameTime’s™ PLUNGERS.
2. Slide the PAUSE/PLAY switch to PAUSE.
3. Reset GameTime™ by holding down the ON/OFF button on the underside of the
clock for a few seconds. Now release the button and press it again to turn
GameTime™ on.
4. Press the SELECT button to see the word PRESET on the display.
5. Use the + and – buttons to change to a preset number between 84 and 91.
6. Slide the PAUSE/PLAY switch to PLAY.
Playing the next game…and the next
When you are ready to play a new game, level the PLUNGERS. Press the ON/OFF
button on the underside of the clock for a couple of seconds until the display clears, and
then press the ON/OFF button again. The GameTime™ is already set to the last preset
time control you selected.
We are ready for a new game.
CHAPTER 2. INTRODUCTION
Getting acquainted with GameTime™
In this chapter we’ll walk around the GameTime™ clock, check under the hood, kick
the tires and get acquainted with all the knobs and gizmos on the dashboard.
What makes GameTime™ tick?
Remove the back base and insert four AA batteries, making sure to follow the diagram
in each battery slot so that the polarity (+ or -) of the batteries is correct.
The unit will beep when batteries are installed. If it does not beep, use a pointed object
and press the ACL button recessed on the bottom of the unit. If that fails to correct the
problem, check battery installation. Numbers will appear on the display panel, if they
8