Emerson iC200 Clock Radio User Manual


 
27
2.) Select the correct adapter for your particular iPod
®
model from among the 5 different adapters included.
Each adapter is engraved with the name and/or size
of an iPod
®
model. Place the selected adapter in the
docking area so that the iPod
®
30-pin connector
passes through the opening in the adapter.
Gently press downward on the adapter until it clicks”
and locks in place.
3.) Mount the iPod
®
Support Bracket on the docking station as shown.
This bracket provides support and prevents your iPod
®
from moving too far
backward when you operate the iPod
®
controls.
CAUTION: You must use this support bracket with all iPod
®
models to
prevent possible damage to the iPod
®
connector.
NOTE: If you are using either the 30GB or 60GB fifth generation iPod
®
models with video capability or the 2G (Second Generation) iPod
®
nano,
use the adapters that were supplied with the iPod
®
at time of purchase.
They will fit correctly in the docking cradle of this system.
IMPORTANT
If you are using a 1G (First Generation) iPod
®
nano”
you will notice that the iPod
®
30-pin connector on
this unit is not properly aligned with the opening in
the iPod
®
nano adapter.
Before inserting the iPod
®
nano adapter into the
docking area you must slide the iPod
®
30-pin
connector to the left position, and then place the
nano adapter into the docking area.
iC200_042007.p65 20/4/2007, 15:4327