Filter
Top Products
5533NNootthhiinngg
Comes Close to a Cobra
®
AAddvvaanncceedd OOppeerraattiioonn
5522
EEnngglliisshh
AAddvvaanncceedd OOppeerraattiioonn
I
ntro Operation Customer
A
ssistance
W
arranty
Notice
Main Icons
Secondary Icons
Caution Warning
I
nstallation
C
ustomer
Assistance
Operating Your Radio
Tri-Watch Mode
Tri-Watch mode gives you one (1) button access to scan a
total of three (3) channels of most importance to you.
Channel 16 is preprogrammed and will always be one (1) of
the scanned locations. Two (2) other channels of your
choice can be stored in the radio. These channels can be
edited and/or recalled during future engagements of
Tri-Watch mode.
NOTE
The radio must be squelched for Tri-Watch mode to
function. See page 37 for Squelch procedure.
Tri-Watch Setup
To Program or Edit the Tri-Watch Channels:
1. Press and hold the TRI-WATCH button for two (2)
seconds to activate Tri-Watch Setup mode. The TRI
and MEM icons on the display will turn On.
NOTE
The main channel number will flash to indicate channel
position. If there is no input activity for 15 seconds, the
radio will sound two (2) beeps and return to Marine
Standby mode.
2. Press Channel Up/Down button to select the desired
Tri-Watch channel.
3. Press and release TRI-WATCH button or
Call/Enter/Setup button to confirm entry.
4. Repeat steps 2 and 3 to program the remaining
additional Tri-Watch memory channel.
5. After programming both Tri-Watch memory
channels the radio will immediately engage
Tri-Watch mode. (See page 53 for further details.)
Intro Operation Customer
Assistance
Warranty
Notice
Main Icons
Secondary Icons
Caution Warning
I
nstallation
Customer
A
ssistance
Intro Operation Customer
Assistance
Warranty
N
otice
Main Icons
Secondary Icons
C
aution Warning
Installation
Customer
Assistance
I
ntro Operation Customer
A
ssistance
W
arranty
Notice
Main Icons
Secondary Icons
Caution Warning
I
nstallation
C
ustomer
Assistance
Operating Your Radio
Using Tri-Watch
Tri-Watch Scan Mode:
1. From Marine Standby mode, press the TRI-WATCH
button. The TRI icon will appear on the LCD display
and the radio will scan through the three (3) Tri-
Watch memory channels.
2. A signal on any one (1) of the three (3) channels
will stop the scan for 10 seconds to allow you to
listen to the traffic on that location.
NOTE
After the Tri-Watch scan stops to monitor a channel,
as long as you do not press any buttons within 10
seconds, your radio will automatically resume
scanning the Tri-Watch channels.
3. Press the Channel Up/Down button to resume
scanning the Tri-Watch channels or to change the
scan direction.
4. To EXIT the Tri-Watch scan, press the TRI-WATCH
button again. The TRI icon will disappear from the
LCD and the radio will return to Marine Standby
mode.
Intro Operation Customer
A
ssistance
Warranty
Notice
Main Icons
S
econdary Icons
Caution Warning
Installation
Customer
A
ssistance
TRI-WATCH Button
TRI and MEM Icons
Channel Up/Down Button
TRI-WATCH Button
Tri-Watch Scan Mode