Filter
Top Products
Intro Operation Customer
A
ssistance
Warranty
Notice
Main Icons
S
econdary Icons
Caution Warning
Installation
Customer
Assistance
IInnttrroodduuccttiioonn
4411NNootthhiinngg
Comes Close to a Cobra
®
4400
EEnngglliisshh
Intro Operation Customer
A
ssistance
Warranty
Notice
Main Icons
S
econdary Icons
Caution Warning
Installation
Customer
Assistance
IInnttrroodduuccttiioonn
Getting Started Setup Mode Programming
High/Medium/Low (H-M-L) Power Button
Your radio can transmit selectively at 1, 3 or 5 watts of
power. Cobra suggests you maintain the low power setting
for short-range communications. You will conserve battery
life and avoid overpowering nearby stations with a low
power setting signal. Use the high power setting for long-
range communications or when you do not receive a
response to a signal sent at 1 watt.
To Toggle Between H-M-L Power Modes:
Press the H-M-L Power button. The LCD will show
which mode is in effect. Some channels are restricted
for a maximum use of 1 watt. Your radio will
automatically set the power to Low Power mode when
you select those channels.
NOTE
Some channels, frequency bands and countries of use
might not be able to operate in High Power mode.
Call /Enter/Setup Button
The Call/Enter/Setup button has multiple functions. It is
generally used in the following ways:
■ Press and release to transmit your unique Call Tone
signal to another radio.
■ Press and hold to enter any Setup menu.
■ Functions as an ENTER button when making a selection
in any Setup menu.
I
ntro Operation Customer
Assistance
W
arranty
N
otice
Main Icons
Secondary Icons
C
aution Warning
Installation
C
ustomer
Assistance
Setup Mode Programming
•
The following series of procedures is designed to allow you to set the programmable
features of your radio. Correctly following these steps results in a minimal amount
of radio setup programming time.
NOTE
When in the Setup mode, if you stop programming for longer than 15 seconds,
your entry will be saved and the radio will go back to the Marine Standby
mode. When you return to Setup mode and continue programming you will see
the last “value” displayed. While in the Setup mode, you will not receive any
signal reception.
Programming these features will allow you to customize certain features of this
radio to enhance your “On-Water” audio needs.
Start from Marine Standby mode to begin Marine (VHF) Setup programming. Press
and hold the Call/Enter/Setup button for two (2) seconds to enter the programming
mode.
Marine (VHF) Mode Programming
I
ntro Operation Customer
Assistance
W
arranty
N
otice
Main Icons
S
econdary Icons
C
aution Warning
I
nstallation
C
ustomer
Assistance
I
ntro Operation Customer
A
ssistance
W
arranty
Notice
Main Icons
Secondary Icons
Caution Warning
I
nstallation
C
ustomer
Assistance
Operating Your Radio
I
ntro Operation Customer
A
ssistance
W
arranty
Notice
Main Icons
Secondary Icons
Caution Warning
I
nstallation
C
ustomer
Assistance
Operating Your Radio
H-M-L Power Button
Call/Enter/Setup Button