Filter
Top Products
VS735 23
Installing into a Universal Bracket Mount in an Alternative
Location (to the floor under a seat or below a package tray)
If installation of the DVD player in an in-dash location is
impossible or undesirable, it can be installed in alternative
locations with the supplied mounting brackets.
1 Determine if you will be floor mounting the unit, or mount-
ing it under a panel. Attach the brackets in the appropriate
direction. Use flat-head machine screws (M5x5) to attach
the brackets to the unit on both sides.
2 Position the unit in place, and secure it with hexagon
washer-head tapping screws (M5x18).
5. Wiring the VS735
The following pages display wiring diagrams for various
VS735 configurations.
Read the following precautions before wiring your system.
• Disconnect the negative battery terminal before making
any wiring connections.
• Be particularly careful where you route wires. Keep them
away from the engine, exhaust system, etc. Heat may
damage wires.
• If the fuse should blow, make sure all connections are
correct and no wires are damaged before replacing the
fuse. Always use fuses that are the same amperage value
as the original. When replacing a fuse, never let the battery
side touch any metal part or any other wire.
WARNING!
Always use great care
when attaching anything
to a vehicle! Visually
inspect all sides of any
potential screw location,
to insure no damage will
occur. If you have ques-
tions about this process,
see your authorized
Clarion dealer.
CAUTION!
Do not overtighten the
screws on uneven sur-
faces! This can cause dam-
age to the VS735. If an even
mounting surface cannot be
found, fabricate a flat panel,
mount the VS735 to it, and
mount that panel to the ve-
hicle.