Filter
Top Products
12-EN
Sound Setting
CDE-9846
CDE-9842
Adjusting Bass/Treble/Balance (Between Left
and Right)/Fader (Between Front and Rear)/
Defeat
1
Press the Rotary encoder (MODE) (CDE-9846
only) or press MODE (CDE-9842 only) repeatedly
to choose the desired mode.
Each press changes the mode as follows:
BASS LV → TRE LV → SUBW* → BALANCE → FADER →
DEFT → VOLUME → BASS LV
Bass level : -7 ~ +10
Treble level : -7 ~ +7
Subwoofer : 0 ~ +15
Balance : L15 ~ R15
Fader : R15 ~ F15
Defeat : ON/OFF
Volume : 0 ~ 35
• If the Rotary encoder is not pressed within 5 seconds after
selecting the BASS LV, TRE LV, BALANCE, FADER, DEFT or
SUBW mode, the unit automatically returns to normal mode.
* When the subwoofer mode is set to OFF, its level cannot be
adjusted.
2
Turn the Rotary encoder (MODE) (CDE-9846
only) or press
44
44
4 and
33
33
3 (CDE-9842 only) until the
desired sound is obtained in each mode.
By setting Defeat ON, previously adjusted settings of
Bass level and Treble level will return to the factory
defaults.
Setting the Bass Control
You can change the bass frequency emphasis to create your own tonal
preference.
1
Press BASS C. (CDE-9846 only) or press CENT.f.
(CDE-9842 only) to select the Bass (bass center
frequency) Control mode.
CDE-9846:
BASS LV ↔ normal
CDE-9842:
BASS LV → TRE LV → normal mode → BASS LV
2-1
Setting the bass center frequency:
Press g or f to select the desired bass center
frequency.
60Hz ↔ 80Hz ↔ 100Hz ↔ 120Hz ↔ 60Hz
The displayed bass frequency is emphasized.
2-2
Setting the bass band width (Q-Factor):
Press BAND to select the desired bass band
width.
Change the boosted bass band width to wide or narrow. A
wide setting will boost a wide range of frequencies above
and below the center frequency. A narrower setting will
boost only frequencies near the center frequency.
2-3
Setting the bass level:
Turn the Rotary encoder (CDE-9846 only) or
press
44
44
4 and
33
33
3 (CDE-9842 only) to select the
desired bass level (–7~+10).
You can emphasize or weaken the bass frequency.
• If no operation is performed within 15 seconds, the bass control
setting will be turned off automatically.
• The bass level settings will be individually memorized for each
source (FM, AM, CD, etc.) until the setting is changed. The bass
frequency and bass band width settings adjusted for one source are
effective for all other sources (FM, AM, CD etc.).
• This function is inoperable when DEFT is set to ON.
Rotary encoder
(MODE)
BAND
g f
BAND
g f
BASS C.
TRE.C.
CENT.f.
MODE
4
3
......................................
→ 1 → 2 → 3 → 4
(Narrow)←→(Wide)