A SERVICE OF

logo

Printer Operation
Load the Printer
23063L-001 Rev. 2 6/21/2004 RXiIIIPlus User Guide 25
From the rear slot in the printer body.
Figure 17 shows the printer with fanfold labels loaded through the rear slot.
Figure 17 • Fanfold Media—Rear Loading
4. Adjust the media guide so it just touches, but does not restrict, the edge of the labels. The
labels should lie flat.
5. Which type of media are you using?
1
Printhead lever (shown in the Open position)
2
Media guide
3
Fanfold labels
If you are... Then...
Using direct thermal
media
Close the printhead and go to Print a Printer Configuration
Label on page 31.
Using thermal transfer
media
Go to Load Ribbon on page 26.
Not sure Go to When to Use Ribbon on page 17.
1
2
3