Specifications
Label Specifications
23063L-001 Rev. 2 6/21/2004 RXiIIIPlus User Guide 119
Label Specifications
RXiIIIPlus printers need the correct size and type of labels for best performance. Refer to the
table that follows for the specifications.
Important • Media registration and minimum label length are affected by label type and
width, ribbon type, print speed, and printer mode of operation. Performance improves as these
factors are optimized. Zebra recommends qualifying any application with thorough testing.
Label Specifications
Minimum label length Tear-off 0.7 in. (18 mm)*
RFID “smart” labels **
Total media width
(label + backing, if any)
Minimum 0.79 in. (20 mm)*
Maximum 4.5 in. (114 mm)
RFID “smart” labels **
Total thickness
(includes backing, if any)
Minimum 0.003 in. (0.076 mm)
Maximum 0.012 in. (0.305 mm)
Roll media core inside diameter 3 in. (76 mm)
Maximum roll diameter on 3 in. (76 mm) core 8.0 in. (203 mm)
Interlabel gap Minimum 0.079 in.(2 mm)*
Preferred 0.118 in. (3 mm)*
Maximum 0.157 in. (4 mm)*
RFID “smart” labels **
Maximum internal fanfold media pack size
(label + backing) L × W×H
8.0×4.5×4.5 in.
(20×114×114 mm)
Ticket/tag sensing notch L × W 0.12×0.25 in. (3×6 mm)
Ticket/tag sensing hole diameter 0.125 in. (3 mm)
Label registration tolerance (vertical) ± 0.06 in. (± 1.5 mm)
Label registration tolerance (horizontal) ± 0.06 in. (± 1.5 mm)
* Does not apply to RFID “smart” labels.
** This parameter varies for each transponder type. For the list of approved transponders and related placement specifications, go
to http://www.zebra.com/PA/Printers/product_R110XiIIIPlus.htm.
