118 RXiIIIPlus User Guide 6/21/2004 23063L-001 Rev. 2
Specifications
Ribbon Specifications
Ribbon Specifications
Refer to the table that follows for ribbon specifications.
Note • Match the ribbon to the label width and printhead width that you are using.
• Ribbon must be wound with the coated side out.
• Ribbon should be at least as wide as the labels to protect the printhead from excessive wear.
Ribbon Specifications R110XiIIIPlus 200 dpi
Printhead resolution 203 dots/inch
(8 dots/mm)
Ribbon width—Minimum* 0.79 in. (20 mm)
Ribbon width—Maximum
4.33 in. (110 mm)
Standard length with 2:1 label to ribbon ratio 984 ft (300 m)
Standard length with 3:1 label to ribbon ratio 1476 ft (450 m)
Ribbon core inside diameter 1.0 in. (25.4 mm)
Maximum ribbon roll outside diameter 3.2 in. (81.3 mm)
* For RFID “smart” labels, the minimum ribbon width is determined by the minimum label width for the
transponder being used. For the list of approved transponders and related size and placement
specifications, go to http://www.zebra.com/PA/Printers/product_R110XiIIIPlus.htm.
