LIFT MOTOR / LIFT ROD
ASSEMBLY INSTRUCTIONS
A. LIFT ROD BUSHING
1. The top bushing assembles through the TOP PANEL and
FRAME. The WAVE WASHER and JAM NUT go BELOW
top part of frame.
2. The bottom bushing assembles through the top hole in the
FRAME BACK PANEL.
B. LIFT MOTOR
1. Apply voltage to the BLACK and WHITE wires of the motor
until the screw stops turning. This is the full-down position.
Turn the BRASS NUT until the distance from the top of the
nut to the top of the screw is 10-1/4” to 10-3/8”.
2. Assemble the LIFT MOTOR to the MOTOR MOUNT
PLATE with four bolts and threadlock.
C. CRADLE PIVOT
1. Assemble the CRADLE PIVOT to the LIFT ROD.
2. The SET SCREW on the PIVOT COLLAR must be
centered on the flat on the LIFT ROD.
D. LIFT ROD YOKE
1. Slide the fingers of the YOKE over the flats of the BRASS
NUT. The set screws must be on the side away from the
motor.
2. Slide the PIVOT / LIFT ROD through the top BUSHING,
YOKE, bottom BUSHING and LIFT ROD GUARD. The
CRADLE PIVOT must be parallel to the rear portion of the
TOP PANEL, with the downturned lip of the PIVOT toward
the front of the fryer.
3. Center the YOKE on the flats of the BRASS NUT, then
tighten the YOKE SET SCREWS on the flat on the LIFT
ROD.
4. Apply voltage to the motor leads and carefully observe the
end points of the up-and-down motion. The yoke must clear
the bushings: adjust by loosening the yoke set screws and
“bumping” the lift motor as required by applying voltage
momentarialy to the appropriate motor leads. Tighten the
set screws and re-test for proper up-and-down operation.
A
A
C
D
B
TOP PANEL
FRAME
LIFT ROD
BUSHING
LIFT ROD
BUSHING
YOKE
LIFT ROD
LIFT
MOTOR
FRAME
BACK PLATE
MOTOR
MOUNT
PLATE
17
