Setup
LED Indicators
The LED indicators on the front panel display the current status of the TVP-224HR
as described in the following table:
Indicator Color Activity Indication
PWR Green On Power is supplied to the gateway.
SYSTEM Green Blinking The system is running. (Heartbeat LED)
LAN
Act
Link
WAN
Link
Act
Green
Green
Green
Green
On
On
Off
On
On
Data is being transferred on the LAN.
The gateway is connected to LAN at 100Mb/s.
The gateway is connected to LAN at 10Mb/s.
The gateway is connected to WAN.
Data is being transferred on the WAN.
LINE
Channels
1-4
Green Off
On
Blinking
The line is idle.
The line is being used.
The line is ringing.
Reset Button
There is a recessed push button located next to the SYSTEM LED. This button
allows you to reset the TVP-224HR or force the TVP-224HR to enter firmware
upgrade mode.
To reset the gateway, push a small, stiff object into the hole until the SYSTEM
LED stops blinking, then release the button.
Powering on the gateway while pressing down the button for 5 seconds forces the
TVP-224HR to enter download mode
1.5 Rear Panel
The rear panel of the TVP-224HR has four analog telephony ports, two FXO and
two FXS ports offering flexible telephony interface usage. The FXS telephony
interface ports may be connected to Subscriber Equipment, such as Telephones,
Fax Machines, Cordless Phones, and Modems. FXO ports can be connected to
PBX and local phone company Central Office (CO) lines. In addition to analog
telephony interface ports, there is a power jack for power adapter connection on
the rear panel.
15
