Black plate (28,1)
<YRD5055-A/U>28
2 Press c or d to select the FM tuning
step.
Pressing c or d will switch the FM tuning
step between 100 kHz and 50 kHz. The se-
lected FM tuning step will appear in the dis-
play.
Note
If seek tuningis performed in 50kHz steps, sta-
tions maybe tuned inimprecisely.Tune inthe sta-
tions with manualtuning or use seektuning
again.
Setting the AM tuning step
The AM tuning step can be switched between
9 kHz, the preset step, and 10 kHz. When
using the tuner in North, Central or South
America, reset the tuning step from 9 kHz (531
1602 kHz allowable) to 10 kHz (530 1640
kHz allowable).
1 Press FUNCTION to select AM.
Press FUNCTION repeatedly until AM appears
in the display.
2 Press c or d to select the AM tuning
step.
Pressing c or d will switch the AM tuning
step between 9 kHz and 10 kHz. The selected
AM tuning step will appear in the display.
Setting the rear output and
subwoofer controller
This units rear output (rear speaker leads out-
put and RCA rear output) can be used for full-
range speaker (R-SP:FUL) or subwoofer
(R-SP:S/W) connection. If you switch the rear
output setting to R-SP:S/W, you can connect
a rear speaker lead directly to a subwoofer
without using an auxiliary amp.
Initially, the unit is set for rear full-range speak-
er connection (R-SP:FUL). When rear output is
connected to full range speakers (when
R-SP:FUL is selected), you can connect other
full range speakers (P/O:FUL) or a subwoofer
(P/O:S/W) to the RCA rear output.
1 Press FUNCTION to select R-SP.
Press FUNCTION repeatedly until R-SP ap-
pears in the display.
2 Press a or b to switch the rear output
setting.
Pressing a or b will switch between
R-SP:FUL (full-range speaker) and R-SP:S/W
(subwoofer) and that status will be displayed.
# When no subwooferis connected to therear
output, select R-SP:FUL.
# When a subwoofer is connectedto the rear
output, set forsubwoofer R-SP:S/W.
# When the rearoutput setting is R-SP:S/W,
you cannot operatethe following procedure.
3 Press c or d to switch the subwoofer
output or rear output.
Pressing c or d will switch between P/O:S/W
and P/O:FUL and that status will be displayed.
Notes
! Even if you changethis setting, there isno
output unless youturn the subwoofer output
on (refer toUsing subwoofer output on page
24).
! If you change thissetting, subwoofer output
in the audiomenu return to thefactory
settings.
Initial Settings
En
28
Section
08
