Epson PM-7000C Manual

A SERVICE OF

next previous

EPSON Imaging Technology Center Page: 49

Revision: 1 (Date: 6/20/00)

6.24 Select Paper Thickness “PH” 02H 00H 00H m1

Format:

“PH” 02H 00H 00H m1

Parameters:

Parameter m1 is one byte binary code, and indicates the state as follows:

Select Paper Thickness m1

Thickness 0.0 mm 00H

Thickness 0.1 mm 01H

Thickness 0.2 mm 02H

Thickness 0.3 mm 03H

Thickness 0.4 mm 04H

Thickness 0.5 mm 05H

Thickness 0.6 mm 06H

Thickness 0.7 mm 07H

Thickness 0.8 mm 08H

Thickness 0.9 mm 09H

Thickness 1.0 mm 0AH

Thickness 1.1 mm 0BH

Thickness 1.2 mm 0CH

Thickness 1.3 mm 0DH

Thickness 1.4 mm 0EH

Thickness 1.5 mm 0FH

Thickness 1.6 mm 10H

Reserved 11H - FFH

Function:

- The default environment paper thickness is set.

- If parameter m1 is out of range, this command is ignored and the existing

setting is maintained.

- This command is only valid in remote mode.

Note:

The setting of platen gap isn’t changed, even if the thickness is set less than 0.5mm by this

command.

However, if the thickness is set more than 0.6mm, the platen gap high is set forcibly.